Abrasive Eraser

Polishing the blade with a whetstone removes any particles and burrs left by the file after sharpening.
The aim is to smooth out any imperfections on the edge that prevent the blade from cutting properly.
Choose the hardness of the stone according to how you intend to use it.
Place your equipment on its edge and secure it with the clamps.
The bindings should face you.
Wear gloves and place the stone on the edge, base-side down.
Pull it towards you, applying gentle pressure.
Run the stone along the entire length of the edge.
Then place the stone on the square and position the whole assembly on its edge.
Make 4 or 5 passes along the entire length.
For a good finish, run the rubber over the edge of the edge, from the tip to the heel, for 5 cm.
Your edges are ready!